Steps to Make a Sliver Snake Cuff Bracelet

The Sliver Snake Cuff Bracelet is built to fit over your hands and on your wrist. This bracelet is made from interlocking loops from various colored paracords. The loops line on both sides from the bracelet with one color along one for reds, and also the other color on the other hand. The double crown knot that joins the finishes from the bracelet provides it with a finished look while keeping the symmetry from the knotting.

Contain the two bits of paracord parallel about 6 inches in the finishes using the red-colored paracord around the left. Go ahead and take short finish from the red-colored paracord round the yellow paracord from behind to create a 1-inch loop round the yellow paracord. Go ahead and take lengthy finish from the yellow paracord and set it with the red-colored loop in the front to create a yellow loop. Work the 2 loops almost but less than snug.

Go ahead and take lengthy finish from the yellow paracord behind and round the red-colored paracord. Place the lengthy finish from the yellow paracord with the red-colored loop in the front. Release the red-colored loop slightly if required. Pull the yellow paracord completely with the red-colored loop. This will make another yellow loop underneath the first yellow loop. Rotate the knot 180 levels to place the yellow paracord around the left and also the red-colored paracord around the right

Go ahead and take lengthy finish from the red-colored cord behind and round the yellow paracord. Place the finish from the yellow paracord into the top bottom yellow loop and pull it the foot of the yellow loop. This will make another red-colored loop underneath the first. Rotate the knot 180 levels to place the red-colored paracord around the left and also the yellow paracord around the right.

Repeat Steps 2 and three before the preferred length is arrived at. Tighten the bracelet by yanking on loops individually, starting with the very best red-colored loop and ongoing lower the chain until all of the red-colored loops are tight. Tighten the yellow loops beginning at the very top in the same manner.

Connect the finishes from the Silver Snake Cuff Bracelet having a crown knot.